Post by Darcey on Oct 21, 2015 16:59:02 GMT
I hope I didn't violate any rules with my previous thread as it is now gone and I needed to recopy the code in it.
It was a code for running 5 servos. 4 of them would be triggered with 1 bend sensor each and one would sweep from 1 to 180 in +5 increments and back every 5 seconds . I've looked all over for examples of similar codes to no avail. Sorry for any mix up or violation but any help is very much appreciated!
Thank you
It was a code for running 5 servos. 4 of them would be triggered with 1 bend sensor each and one would sweep from 1 to 180 in +5 increments and back every 5 seconds . I've looked all over for examples of similar codes to no avail. Sorry for any mix up or violation but any help is very much appreciated!
Thank you
